Sprinkler Repair in Idaho Falls

Common Sprinkler Problems We Diagnose & Fix

Most irrigation failures fall into a predictable set of categories, and identifying which one you’re dealing with shapes everything about the repair approach.

Broken or Clogged Sprinkler Heads:
Heads crack from foot traffic, lawn equipment, or freeze damage. A clogged nozzle produces uneven spray patterns and dry zones. These are among the most frequent repair calls we receive, and most head replacements are completed during the initial visit.

Underground Pipe & Fitting Damage:
Ground movement and Idaho Falls’ freeze-thaw cycles can crack buried pipes and split fittings. Symptoms include soggy patches, sudden drops in water pressure, or zones that won’t reach full coverage. We locate and repair underground damage without unnecessary excavation.

Valve Failures:
A faulty valve causes a zone to stay on when it shouldn’t, fail to turn on at all, or operate erratically. Left unaddressed, valve problems lead to overwatered or chronically dry areas, depending on which direction the failure runs.

Irrigation Controller Issues:
When scheduled cycles don’t run or zones fire out of sequence, the controller is often the source. We diagnose both the hardware and its programming to determine whether the fix is a setting correction or a component replacement.

Water Pressure Problems:
Pressure that’s too high damages heads and fittings over time. Pressure that’s too low reduces coverage and leaves dry patches. We test system pressure as part of every diagnosis so the root cause gets addressed, not just the visible symptom.

Drip System Repairs:
Blocked emitters and damaged drip lines cut off water to individual plants or planting beds. We service drip irrigation components alongside conventional spray and rotor systems.

What to Expect During a Repair Visit

Our technicians begin with a full system diagnosis, running each zone to determine whether the problem is isolated or affecting multiple areas. That walkthrough shapes the repair plan and gives you a clear picture of what’s needed before any work begins.

Because we carry a robust parts inventory, we’re able to complete most repairs on the same visit rather than scheduling a return trip. We also work on systems we didn’t install: if your irrigation system was put in by another company, we can still diagnose and repair it. Once the repair is complete, we run all zones again to check coverage before we leave.